Programming for HomeLink® System


5 Steps To Program Your HomeLink® System


Note: Some vehicles may require the ignition be turned on or the vehicle actually running to program the Homelink® transceiver.

To program a rolling code compatible Homelink® system, please follow these steps.

1

 Press and hold the two outside buttons on the Homelink® system until the LED starts to blink, release buttons

2

 Press and hold the desired Homelink® button and the transmit button on your rolling code transmitter at the same time until the Homelink® LED changes from a slow blink to a rapid blink. (Your Homelink® system is now programmed)

3

 Locate the learn code button on your garage door opener. (These are located under the light cover or on the rear panel depending on model)

4

 Press the learn code button on the garage door opener, a red LED will start to blink. (You will have 30 seconds to complete programming)

5

 While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed Homelink® button 4 times. (Or until the garage door operates).

Homelink® is a registered trademark of Johnson Controls, Inc.